1. Drone components and their functions (frame, motors, ESCs, flight controller, power system, sensors, radio and video links)
2. Principles of flight control, stabilization, and flight modes
3. Flight controller firmware structure and configuration concepts
4. Sensor setup and verification (IMU, compass, GPS – where applicable)
5. Motor and ESC configuration and safety checks Power management, batteries, and electrical safety
6. Assembly of the drone using modular, solderless components
7. Introduction to flight control and configuration firmware (Betaflight)
8. System configuration, parameter checks, and troubleshooting basics
9. Pre-flight inspection and safety procedures
10. Controlled test flight and basic flight evaluation

• Interactive classroom sessions introducing key technical concepts Instructor-led demonstrations of components, system architecture, and configuration steps
• Guided practical assembly of a multirotor drone using solderless, modular components
• Supervised configuration exercises using flight controller software (Betaflight)
• Group-based troubleshooting and discussion of common setup issues
• Step-by-step pre-flight checks and safety briefings
• Supervised and controlled test flight to validate assembly and configuration
• Emphasis is placed on learning by doing, system understanding, and safe operational practices.

Other than that, the prerequisites for the course are the following:

• Basic computer skills are necessary (use of configuration software)
• Basic understanding of drone operations is recommended but not mandatory
• Compliance with safety instructions and operational procedures during practical sessions
• Participants are not required to have soldering skills, as the drone assembly is carried out exclusively using solderless components.
• No prior experience in drone assembly or electronics is required

• Aspiring drone pilots seeking a deeper technical understanding of multirotor systems
• Professional drone operators who want to better understand the technical behavior of their aircraft
• Technical staff involved in drone operations, maintenance, or system preparation Engineers, technicians, or hobbyists with an interest in UAS hardware and flight control systems
• Trainers or instructors who require a practical overview of drone assembly and configuration...

Price: €80

Required equipment: Participants must bring their own laptop to attend the training.

Technical prerequisites: No welding skills are required. The drone assembly is carried out exclusively using solder-free components, making the session accessible to all levels.